Today I finished the throttle pockets, after some investigation the Luan Ply I was using for the testing phase was not a recommend material for lasers, so I purchase some Baltic Birch Ply which was delivered today. I also left the T&P Logo with a small change at the request of my local N Scale buddies.
Here are the four final pocket :
I also made up some un-coupler picks, using #8 tapestry needle and a 3/16" diameter x 4" long dowel from some internet discussions.
Tomorrow I will apply a sealer to the pockets and mount them once they dry in a few days.
Very cool Dwayne. Your throttle pockets look very good.
ReplyDeleteI've made some un-couplers using knitting needles and fitting Ramset wall plugs over the ends.
Regards
Rod.